EETI QNX UART Driver Installation Note

Revision    : 1.2.3314
OS        : QNX Neutrino RTOS v6.5
Release Date    : 2015/08/14
Interface : RS232


File List:
1. eeti_devi
2. devu-touch-mouse
3. AP
4. touchload.sh
5. driver_install.sh
6. EETI_UserSetting.ini

Steps(Please operating in console mode):

1. Go to target machine subdirectory(which like X86, arm or other), then change the driver_install.sh permissions and make the file executable.
    Example:    chmod +x driver_install.sh

2. Execute driver_install.sh
    Example:    sh driver_install.sh

3. Edit /root/.profile and add the following at the end of .profile
    sh touchload.sh
    
4. Reboot system.


Trouble shooting:

1. If you want to change another EETI touch device, please reboot your system or re-run touchload.sh.
  
2. The touch point is not the position you touched. Please execute the AP program and do calibration. You can use drawtest to test your calibration result.
 
3. If there are other problems, please contact us and send the information file which in /var/log/info by email: touch_fae@eeti.com